5.1.27. Configuration M250 (pcfg_Config_M250)
Prev 5.1. OpenECU blockset reference Next

5.1.27. Configuration M250 (pcfg_Config_M250)

Specific configuration for the M250 target ECU.

5.1.27.1. Supported targets

M250-000

5.1.27.2. Required license

None (Main library). (See Section 2.3, “Licensed Features”.)

5.1.27.3. Description

The pcfg_Config_M250 block configures pin A32, A33 and A34 to act as an injector output or as a PWM output. If the pin is configured as a PWM output, then the block can also configure the current trip level for each pin.

If the block is not present in a model, then the platform software configures pins A32, A33 and A34 as a PWM output with a current trip level of 5A during model initialisation.

5.1.27.4. Inports

None.

5.1.27.5. Outports

None.

5.1.27.6. Mask parameters

  • Signal type (pin A32)

    The output type for pin A32, either injector output or PWM output.

  • Signal type (pin A33)

    The output type for pin A33, either injector output or PWM output.

  • Signal type (pin A34)

    The output type for pin A34, either injector output or PWM output.

5.1.27.7. Notes

If the block is not present in a model, then the platform software configures all pins as a PWM output with a current trip level of 5A during model initialisation.

Prev Up Next
5.1.26. Configure auto-coder (RTW RTMODEL) (prtw_ConfigUsingRtwRtmodel) Home 5.1.28. Configuration M460 (pcfg_Config_M460)