5.1.32. Constant current output — autozero for TLE8242-2 channels (pax_CcAutozeroTle8242)
Prev 5.1. OpenECU blockset reference Next

5.1.32. Constant current output — autozero for TLE8242-2 channels (pax_CcAutozeroTle8242)

Command a TLE8242-2 constant current channel to autozero.

5.1.32.1. Supported targets

M670-000

5.1.32.2. Required license

None (Main library). (See Section 2.3, “Licensed Features”.)

5.1.32.3. Description

This block allow the application to initiate autozero of a TLE8242-2 device channel. The channel will be zeroed over the next four pulse periods. The current setpoint must be set to zero before triggering the autozero feature. TLE8242-2 channels cannot be autozeroed in parallel.

5.1.32.4. Inports

  • activate

    A value of 1 at this inport will request the TLE8242-2 to initiate the autozero sequence for the specified channel.

    Range: 0 or 1

5.1.32.5. Outports

  • complete

    This outport is pulsed upon the completion of the autozero sequence.

    Range: 0 or 1

5.1.32.6. Mask parameters

  • Channel

    The channel pin for this constant current output.

    Value type:List
    Calibratable:No

5.1.32.7. Notes

Only one autozero block may be active at any time. If autozero is desired for multiple channels, then the application must contain logic to schedule the activation of each block appropriately.

Prev Up Next
5.1.31. Constant current output — configuration for TLE8242-2 outputs (pax_CcConfigTle8242) Home 5.1.33. Constant current output — monitor for TLE8242-2 channels (pax_CcReadCurrentTle8242)