This chapter gives you a quick introduction to building and simulating models, and an introduction to programming the OpenECU device.
The step1 exercise in Section 3.3, “Exercise — Step 1” describes how to incorporate the Pi OpenECU blocks into your own Simulink designs, and how to test and calibrate your models on the ECU. The exercise requires the following resources:
a working knowledge of MATLAB and Simulink;
a complete installation of Pi's OpenECU Simulink blocks: see Chapter 1, Installation;
a complete installation of supporting tools (e.g., compiler, calibration tool, etc.: see Chapter 1, Installation and Appendix 2, Supporting tools);