5.1.117. Waveform — set channel (prop_WaveformSetChannel)
Prev 5.1. OpenECU blockset reference Next

5.1.117. Waveform — set channel (prop_WaveformSetChannel)

Specify the waveform for a output channel.

5.1.117.1. Supported targets

M670-000

5.1.117.2. Required license

None (Main library). (See Section 2.3, “Licensed Features”.)

5.1.117.3. Description

This block configures the waveform to use for an output channel. The waveform must be setup using a prop_WaveformConfig block.

5.1.117.4. Inports

None.

5.1.117.5. Outports

None.

5.1.117.6. Mask parameters

  • Waveform

    A drop down to identify the waveform to select. The selection of waveform is dependent on the target ECU hardware selected in the put_Identification block.

    Value type:List
    Calibratable:No

  • Channel

    The channel to associate with the configured waveform.

    Value type:List
    Calibratable:No

5.1.117.7. Notes

None.

Prev Up Next
5.1.116. Waveform — configuration, phases (prop_WaveformConfig) Home 5.2. Automatic ASAP2 entries